13
English
DESCRIPTION
Log lifter (A)
The log lifter is designed for raising the smaller
end of the log, so that the heartwood will be
horizontal.
Log locking device (C)
The log locking device consists of an eccentric
link with handle, journalled in a moveable unit.
The locking device is used for securing the log
against the folding stops.
A
B
C
Rail assembly
The rail assembly consists of two sections
(standard supply). Each section is 3 m long. The
sections are to be arranged in-line and screwed
together to form a track for the carriage. The rail
sections are screwed together and anchored by
M 12-screws with nuts. Thish ensures stable and
linear carriage movement.
The rails also have a number of supporting
cross-beams, which are designed to provide
stable support for the log, which is to be sawn
into planks or for planks, which are to be trim-
med.
The rail cross-beams are equipped with:
• folding stops for the log
• Log locking device
• Log lifter for one end of the log
The rail assembly is also equipped with stops at
both ends for the saw carriage and specially
adjusted transition pieces at its joints.
Folding stop (B)
On the left side of the rails, there are a number of
folding stops for holding the log in place. For
enhanced versatility, the stops of two lengths are
provided.
To Next Page
Loading...