4 – English
Arrangement of the manual
This workshop manual can be used in two different
ways.
• To repair a specifi c sub-assembly on a chainsaw.
• To dismantle and reassemble a complete chain-
saw.
Repairing a specifi c sub-assembly
If a specifi c sub-assembly on the chainsaw needs
to be repaired:
1. Look up the page referring to the relevant sub-
assembly.
2. Follow the instructions under the headings:
Removal/Dismantling
Cleaning and inspection
Refi tting/Reassembly
Dismantling and reassembling the entire chain-
saw
If the entire chainsaw is to be dismantled, follow
the instructions under the heading “Removal/Dis-
mantling”.
Work through the manual and follow the instruc-
tions given in each section under the heading
“Removal/Dismantling”.
Then follow all the “Cleaning and inspection” in-
structions in each section.
Working from the back of the manual, follow all the
instructions under the headings “Refi tting/Reas-
sembly” in reverse order.
Each of the sections covering removal/dismantling
and refi tting/reassembly include the relevant lubri-
cation instructions and bolt torques for each stage
of repair.
Construction and function
This chapter gives a simple description of the
chainsaw carburettor and its various parts.
Introduction
Troubleshooting
These pages describe the most common faults that
affect a chainsaw. They are divided into four dif-
ferent groups with the most likely faults described
fi rst.
Repair instructions
The section that describes how to repair the chain-
saw consists of detailed, step-by-step instructions.
It explains in detail the special tools, lubricants
and bolt torques that are needed when working on
each component.
This workshop manual covers the following
chainsaw models:
CS 2141
CS 2145
CS 2147
CS 2147 C
CS 2147 WH
CS 2147 CWH
CS 2149
CS 2149 WH
CS 2150
CS 2152
CS 2152 C
CS 2152 WH
CS 2152 CWH
CS 2156
CS 2156 C
CS 2156 WH
CS 2156 CWH
CS 2159
CS 2159 C
CS 2159 WH
CS 2159 CWH
To Next Page
Loading...
Need help?
General