How to fix over rich acceleration on Jonsered Chainsaw?
To fix over rich acceleration in your Jonsered Chainsaw, consider these steps: Adjust the L and H screws. Also, check for a blocked air filter, a faulty pump diaphragm, or faulty diffuser jets.
How to fix Jonsered CS 2166 Chainsaw that will not “four-stroke”?
To address a Jonsered Chainsaw that will not 'four-stroke', you can try: Checking for a blocked fuel tank vent or fuel filter, a blocked fuel line, or a loose/damaged fuel hose. Also, inspect for a leaking or blocked impulse channel, a loose cover on the carburettor pump side, or a faulty pump diaphragm. Other possible causes include a leaking air intake hose, loose carburettor mounting bolts, a needle valve set too low, a leak in the metering system, an incorrectly assembled metering unit, a loose diaphragm rivet, a hole in the diaphragm, or a leaking control diaphragm/cover plate.
General| Power Output | 3.2 kW |
|---|---|
| Chain Pitch | 0.325 inches |
| Fuel Tank Volume | 0.5 L |
| Oil Tank Volume | 0.25 L |
| Engine displacement | 64.1 cm³ |
| Chain Gauge | 1.5 mm |
| Weight (without cutting equipment) | 5.8 kg |
To Next Page
