Jonsered FC2256W - Page 37

English – 37
TECHNICAL DATA
Note 3: Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1 m/s
2
.
FC2256, FC2256W
Approved accessories Type Cutting attachment guard, Art. no.
Centre hole in blades/cutters, Ø 25,4
mm
Output shaft thread M12
Grass blade/grass cutter
Multi 275-4 (Ø 275 4 teeth) Set 502 46 49-02
Multi 300-3 (Ø 300 3 teeth) Set 502 46 49-02
Multi 350-3 (Ø 350 3 teeth) Set 502 46 49-02
Saw blade
Maxi 225-24 (Ø 225 24 teeth) 544 01 65-01
Scarlet 200-22 (Ø 200 22 teeth) 537 21 71-01
Scarlet 225-24 (Ø 225 24 teeth) 544 01 65-01
Trimmer head
Trimmy S II (Ø 2.4 - 3.3 mm cord) Set 502 46 50-02
Tap-N-Go 45 Spin (Ø 2.7 - 3.3 mm
cord)
Set 502 46 50-02
Tap-N-Go 55 Spin (Ø 2.7 - 3.3 mm
cord)
Set 502 46 50-02
F55 (Ø 2.7 - 3.5 mm cord) Set 502 46 50-02
Support cup
Fixed
With ball bearing
BC2256
Approved accessories Type Cutting attachment guard, Art. no.
Centre hole in blades/cutters, Ø 25,4
mm
Output shaft thread M12
Grass blade/grass cutter
Multi 275-4 (Ø 275 4 teeth) 544 16 03-02
Multi 300-3 (Ø 300 3 teeth) 544 16 03-02
Multi 350-3 (Ø 350 3 teeth) 544 16 03-02
Saw blade
Maxi 225-24 (Ø 225 24 teeth) 544 01 65-01
Scarlet 200-22 (Ø 200 22 teeth) 537 21 71-01
Scarlet 225-24 (Ø 225 24 teeth) 544 01 65-01
Trimmer head
Trimmy S II (Ø 2.4 - 3.3 mm cord) 544 10 74-04
Tap-N-Go 45 Spin (Ø 2.7 - 3.3 mm
cord)
544 10 74-04
Tap-N-Go 55 Spin (Ø 2.7 - 3.3 mm
cord)
544 10 74-04
F55 (Ø 2.7 - 3.5 mm cord) 544 10 74-04