Why my Jonsered Chainsaw does not start?
If your Jonsered Chainsaw doesn't start, several factors could be at play. Ensure the power is on. Check that the battery pack is correctly installed and making proper electrical contact. The battery pack might need charging, or it could be too hot or too cold. Also, the motor controller might be too hot; let the battery pack and product cool down for at least an hour before attempting to restart.
What to do if red LED flashes and LED 2 flashes green on Jonsered HT2258 Li?
When the RED LED flashes and LED 2 flashes green when the battery pack is installed in your Jonsered Chainsaw, it indicates that the internal battery temperature is either too low or too high. To resolve this, ensure the internal temperature of the battery is between -15°C (5°F) and 70°C (158°F). If the battery pack is too cold, move it and the battery charger to a warmer environment. If it's too hot, move them away from the hot environment, especially after operation.
What to do if red LED is on and LED 2 flashes green on Jonsered Chainsaw during charging?
If the RED LED comes on, and LED 2 is green and flashes during charging or when the battery pack is in the battery charger of your Jonsered Chainsaw, it means the internal battery temperature is too low or too high for charging. Move the battery charger and battery pack to a location where the internal temperature of the battery pack is between 5°C (41°F) and 45°C (113°F).
What does it mean if LED 4 is green on Jonsered Chainsaw?
If LED 4 is green on your Jonsered Chainsaw, it indicates that the battery pack is overcharged. Remove the battery pack from the battery charger and install it in the product. Operate the product. The battery charger may be defective, speak to an approved service center.
What to do if blades do not move on Jonsered Chainsaw?
If the blades of your Jonsered Chainsaw do not move, it is likely because they are blocked. Remove any unwanted material that is obstructing the blades.
What does it mean if LED 1 is red and LED 2 is green on Jonsered HT2258 Li Chainsaw?
If LED 1 is red and LED 2 is green, and the battery pack does not charge or operate correctly in your Jonsered Chainsaw, it indicates a battery pack failure. Remove the battery pack from the product and do not attempt to charge it. The battery pack is damaged and needs replacement. Speak to an approved service center.
What does it mean if LED 1 is red on Jonsered HT2258 Li Chainsaw?
If LED 1 is red on your Jonsered Chainsaw, it indicates irregular cell voltage. Speak to an approved service center.
What does it mean if LED 1 is red and LED 4 is green on Jonsered Chainsaw?
If LED 1 is red and LED 4 is green, and the battery pack does not charge or operate correctly in your Jonsered Chainsaw, it indicates an internal fuse is blown. Speak to an approved service center.
Describes the various components and parts of the product.
Explains the meaning of safety icons and markings found on the product.
Outlines the manufacturer's responsibilities and limitations regarding product damages.
Defines severity levels for warning signal words like DANGER, WARNING, CAUTION.
Provides essential safety precautions for operating power tools.
Covers operator attentiveness, protective equipment, and proper attire.
Specific safety advice and precautions for using the hedge trimmer.
Guidelines for safe handling, charging, and storage of battery packs.
Broad safety rules for correct product usage and maintenance.
Safety precautions to prevent injury or damage during maintenance.
Essential checks to perform before starting the product.
Steps for battery installation and motor startup procedures.
Instructions on how to effectively and safely cut hedges.
Explains the meaning of LED indicators for battery charge level.
Routine cleaning and inspection tasks for daily upkeep.
Guidance on resolving common problems and interpreting error signals.
To Next Page
General
