x2
HOTTAP
1110
USER GUIDE
Setting up Hottap
1. Install 2 D-cell batteries
observing the labelling on
the battery box and the
batteries.
2. Using a spanner, connect
the female GasKnect
tting to the gas hose.
Do not use thread tape
Connect the regulator
to the gas bottle and
the GasKnect to the
Hottap unit.
The gas cylinder must be
positioned away and to
the side of the appliance.
It must never be directly
beside, below or above
the appliance.
Before setting up, please note that Hottap requires a water
pressure of at least 70kPa to work. This part of the guide
assumes that you have access to mains water.
For use with the O-Grid Plumbing kit, please refer to
pages 20-21.
To set up your Hottap for use, please cover the following steps:
To Next Page
Loading...
