12
Playpen Mode
• Keep children away from playpen while unpacking and assembling.
• Open the travel bag and remove the playpen. The playpen comes fully assembled.
• Push both legs outward. (13) Ensure the legs lock into place by gently jiggling the legs. The joints
should be rmly engaged.
• Thread the four straps at the bottom of the bassinet fabric through the corresponding plastic rings
on the legs and secure the Velcro®. (14)
• The mattress comes rst installed in bassinet mode (upper position).
• To install the mattress in playpen mode (lower position) after use in bassinet mode, release the
buckle on the mattress. (15) Unzip the mattress until it disengages from the bassinet. (16)
• Place the mattress at the bottom of the playpen.
• Locate the Velcro® straps near the corners of the mattress.
• Slide one corner strap through the slot in the oor of the playpen and secure to the underside of
the playpen. (17) Repeat for the other three corners.
NOTE: Make sure the storage zipper is completely closed in playpen mode.
IWARNING: Prevent possible strangulation or
entanglement. Never use sheet unless it ts securely on mattress.
DO NOT use the rocking position when in playpen mode (lower position).
Assembly and Usage
15
13
16
14
To Next Page
Loading...
