JOPIX AN-2 - SWR Test; Resume Factory Default (RST); General Settings for All Channels (PD); General Channel Settings

English - 13 -
6.13.- STANDING WAVE RATIO TEST (SWR):
Note:
- Connect a 50 Ω load before testing SWR.
1. Enter settings menu and choose NO.13 function menu.
2. Press channel selector knob to enter function setting.
3. Turn channel selector knob to choose wanted setting.
Continue: Enter into SWR testing.
No: Exit function.
4. Press channel selector knob to confirm.
6.14.- RESUME FACTORY DEFAULT (RST):
1. Enter settings menu and choose NO.14 function menu.
2. Press channel selector knob to enter function setting, the chosen value in LCD will
turn to green color.
3. Turn channel selector knob to choose wanted setting.
OPT: All function settings will reset to the factory default.
ALL: All channel and function settings will reset to the factory default.
4. Press channel selector knob to confirm.
5. Press [F3] key to stop and exit reset function.
7
.
-
GENERAL SETTINGS FOR ALL CHANNELS (PD)
:
How to enter single configuration:
1. Press and hold [FUNC] key to enter main menu.
2. Press [F4], [F6] key or turn channel selector knob to move cursor and choose
setting menu. Press [F5] key can fast turn page.
3. Press channel selector knob to enter PUD MENU.
4. Press [F4], [F6] key or channel selector knob to move cursor and choose desired
setting.
5. Press channel selector knob to enter function setting, the chosen value in LCD will
turn to green color.
6. Turn channel selector knob to choose wanted setting.
7. Press channel selector knob or [F3] key to confirm and exit.
Note:
- This menu offer one-time setting for all channels.
N
o.
LCD Display
Fun
ct
i
o
n
Set
ting details
1 A/FM XXX AM/FM switch.
FM: Turn on FM mode.
AM: Turn on AM mode.
2 NB XXX
NB/ANL function
setting.
OFF: Turn off NB/ANL function.
ON: Turn on NB/ANL function.
3 HIC XXX HI-CUT on/off.
OFF: Turn off HI-CUT function.
ON: Turn on HI-CUT function.
4 RB XXX
Roger Beep (RB)
setting.
OFF-5, total 6 groups.
OFF: Turn off RB function.