JOTRON electronics a.s.
December, 99
Page 19
➂
DC INPUT CONNECTOR
Input for external DC. The DC voltage should be at nominal battery voltage, app. 27V
and rated for 5A continuous current consumption.
The transceiver will automatically draw the current from this input when the AC
voltage is not present.
Pin A is 27 V DC.
Pin B is internal ground (0V) - not chassis!
➃
➃➃
➃
AC INPUT CONNECTOR
Input for external AC.
AC is input between A and C, B is chassis ground.
The voltage should be 230VAC ± 10% or optionally 115 ± 10%.
To use 115VAC the transceiver must be rewired internally, see WIRING DIAGRAM
for details.
To Next Page
