15
ENGlish
Table of contents
1.0 Relationship to the authorities ..................15
2.0 Technical data ..............................................15
3.0 Safety precautions ......................................16
4.0 Installation .................................................16
5.0 Use ...............................................................18
6.0 Maintenance ...............................................19
7.0 Service ..........................................................20
8.0 Reasons for operational problems -
troubleshooting ..........................................20
9.0 Optional equipment ...................................20
Figures ................................................................56
1.0 Relationship to the
authorities
Installation of the fireplace must be according to local
codes and regulations in each country. All local regulations,
including those that refer to national and European
standards, shall be complied with when installing the
product.
Instructions for mounting, installation and use are
enclosed with the product. Prior to using the product the
installation must be approved by a qualified person.
A product data plate in heat resistant material is located
on the heat shield at the back of the product. This contains
information about identification and documentation for
the product.
2.0 Technical data
Material: Cast iron
Finish: Enamel or black paint
Fuel: Wood
Log length, max.: 40 cm
Operating range: 2.7-7.5 kW
Flue outlet: Top and rear
Flue pipe dimension:
- inside : Ø125 mm/123 cm
2
cross
section
- outside : Ø 150mm/177 cm
2
cross section
Approx. weight: 97 kg
Optional extras: Enamelled floor plate,
long legs
Product dimensions, distances: See fig. 1
Technical data according to EN 13240
Nominal heat output: 5.5 kW
Flue gas mass flow: 5.0 g/sec
Recommended chimney draught: 12 Pa
Efficiency: 78%
CO emission (13% O
2
): 0.18%
Flue gas temperature: 298
o
C
Operational type: Intermittent
To Next Page
Loading...
Need help?
General
