10
Fig. 6b
8. Knock out the removable cover plates (fi g. 6b A).
9. Attach the smoke outlet (fi g. 6a A) on the inside of the burn
chamber where the cover was.
10. Install the cover (fi g. 6a B) where the smoke outlet was.
11. Refi t the exhaust defl ectors (fi g. 4 B) and the baffl e plate
(fi g. 4 A).
4.7 Control of functions
When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Jøtul F 162 and F 163 are equipped with the following control:
Ignition vent/air vent
Ignition
Fig. 7a
• Open the ignition vent and air vent by pulling the handle all
the way out. (Use a glove or something similar to protect
your hand in case the handles are hot.)
• Place two logs at the bottom of the burn chamber and pile
the kindling in layers.
• Finally, place a medium-sized log on the top of the pile.
• Place 2 or 3 briquettes or kindling sticks under the top layer
of kindling and light the fi re.
Heating
Fig. 7b
• Leave the ignition-/air vent 24 mm (fi g. 7 B) open when the
wood has caught fi re properly and is burning well.
• Close the door.
• You can then regulate the rate of combustion to give the
heat you want by adjusting the air vent.
• Check that the afterburning (secondary combustion) starts.
This is best indicated by yellow, fl ickering fl ames in front of
the holes under the baffl e.
Adding fi rewood
Stoke the stove frequently but only add small amounts of fuel at
a time. If the stove is fi lled too full, the heat created may cause
extreme stress in the chimney. Add fuel to the fi re in moderation.
Avoid smouldering fi res as this produces the most pollution.
The fi re is best when it is burning well and the smoke from the
chimney is almost invisible.
ENGLISH
To Next Page
Loading...
Need help?
General
