To Next PageTo Next Page
Need help?Do you have a question about the Jøtul F 500 and is the answer not in the manual?
General| Brand | Jøtul |
|---|---|
| Model | F 500 |
| Category | Wood stove |
| Language | English |
Key safety warnings and prohibitions for operating the wood stove.
Steps for assembling the stove components prior to installation.
Guidelines for selecting and installing the chimney connector pipe.
Details on required chimney types, size, and height for proper draft.
Specific requirements for installing the stove with masonry chimneys.
Guidelines for using tested and listed prefabricated metal chimneys.
Minimum and recommended chimney heights for adequate draft.
Methods for safely passing chimney connectors through combustible walls.
Proper connection methods for thimbles in masonry chimneys.
Instructions for installing the stove into an existing masonry fireplace.
Procedures for connecting the stove to prefabricated metal chimneys.
Specifications for non-combustible floor protection under the stove.
Minimum safe distances from combustible surfaces to the stove.
Specific requirements for installing the stove in an alcove.
Approved procedures for installing the stove in mobile homes.
Factors affecting stove efficiency and optimal performance.
How to reduce CO emissions and the importance of CO monitors.
Recommended wood types, moisture content, and fuels to avoid.
Understanding and adjusting primary and secondary air controls for optimal burn.
Steps to gradually heat the stove to prevent damage from thermal expansion.
Methods for building and managing fires for efficient burning.
Information on creosote buildup, risks, and removal methods.
Proper procedure for reloading the stove with fuel.
Recommended annual inspection steps for stove condition.
How to safely remove ashes from the stove using the ash pan.
Routine inspection and cleaning of the chimney and connector.
Proper methods for cleaning and maintaining the stove's enamel finish.
How to clean the stove's glass panel to prevent etching.
Step-by-step guide for replacing the stove's glass panel.
How to check and replace door and glass panel gaskets for a proper seal.
Information on using the firescreen for open fireplace operation.
Description of heavy-duty, flame-retardant stove gloves.
Kit containing all necessary gasket material for the stove.
Kit for connecting an outside air source for combustion.
Kit required for securing the stove in mobile home installations.
Heatshield designed to reduce rear clearance to combustible materials.
Heatshield required for alcove installations and included with stove.
Recommended tool for monitoring stove surface temperature.
Kit to lock the side load door for alcove/corner installations.
Kit for leveling the stove using its legs.
Kit for replacing stove door knobs.
Minimum clearances for parallel installations with unprotected surfaces.
Minimum clearances for parallel installations with protected surfaces.
Minimum clearances for corner installations with unprotected surfaces.
Minimum clearances for corner installations with protected surfaces.
Minimum clearances for vertical chimney connector installations.
Minimum clearances for horizontal chimney connector installations.
Safe distances for combustible trim and mantels near the stove.
Definitions of thermal conductance, conductivity, and resistance terms.
An example demonstrating how to calculate R-value for floor protection.
Warranty coverage for baffle and air manifold components.
Warranty for cast iron and steel components of the stove.
Warranty for the enamel finish against peeling or fading.
Warranty for electrical components like blowers.
Conditions and scenarios not covered by the product warranty.
