EasyManuals Logo

Jøtul F 370 Advance Series User Manual

Jøtul F 370 Advance Series
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
17
4.8 Performance check
Once the product has been assembled, always check the
control handles. These should move easily and work in a
satisfactory manner.
The Jøtul F 370 Advance is equipped with the following
operating options:
Fig. 30
Maximum
Minimum
Lighting the fire
A
B
C
Air and ignition vent (A)
Pushed in: Closed
Pulled out fully: Open
Door handle (B):
Open by pulling the handle out.
Stacking height (C) for logs (the holes must not be covered).
4.9 Use
Open the air vent and the ignition vent by pulling it out all
the way (A). If necessary, keep the door slightly open. (Use
a glove, for example, as the handle can become hot.)
Place two medium sized logs in/out on each side of the
base. N.B. In order to avoid sooting on the glass, it is
important that the log is not placed adjacent to the glass
on the product.
Crumple some newspaper (or birch bark) between these
and add some kindling wood in a criss-cross pattern on top
and light the newspaper.
Gradually increase the size of the re, but the wood should
not be stacked higher than the horizontal holes on the back
burn plate. See g. 30 C.
Finally, place a medium-sized log on the top of the pile.
Place 2 or 3 briquettes or kindling sticks under the top layer
of kindling and light the re.
NB: The maximum height of the pile of the wood should
be just below the horizontal holes. The holes must not be
covered.
Check that the afterburning (secondary combustion) starts.
This is best indicated by yellow, ickering ames under the
baf e.
Then regulate the rate of combustion to the desired level of
heating by adjusting the air vent ( g. 30 A).
Close the stove door. It must always be closed when the
re is lit.
Fig. 31
Adding rewood
Stoke the stove frequently but only add small amounts of fuel
at a time. If the stove is lled too full, the heat created may
cause extreme stress in the chimney. Add fuel to the re in
moderation. Avoid smouldering res as this produces the most
pollution. The re is best when it is burning well and the smoke
from the chimney is almost invisible.
ENGLISH

Other manuals for Jøtul F 370 Advance Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jøtul F 370 Advance Series and is the answer not in the manual?

Jøtul F 370 Advance Series Specifications

General IconGeneral
BrandJøtul
ModelF 370 Advance Series
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals