23
8.0 Operational problems -
troubleshooting
Poor draught
Check the length of the chimney and that it complies with
national laws and regulations. (See also «2.0 Technical
data» and «4.0 Installation» (Chimney and fl ue pipe) in the
installation manual for information.)
Make sure that the minimum cross section on the chimney
is according to «2.0 Technical data» in the installation manual.
Make sure that there is not anything preventing the smoke
gasses from escaping: branches, trees, etc.
Upon suspicion of excessive/poor draught in the chimney,
seek professional help for measurement and adjustment.
The fi re extinguishes after a while
• Make sure that the fi rewood is suffi ciently dry.
• Find out whether there is negative pressure in the house,
close mechanical fans and open a window close to the
fi replace.
• Check that the air vent is open.
• Check that the fl ue outlet is not clogged by soot.
Unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity
depends on:
• Moisture in the fuel.
• The local draught conditions.
• Air vent opening.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.
(See «6.1 Cleaning the glass».)
9.0 Optional equipment
9.1 Rotating kit
(See separate installation manual)
Rotating set for Jøtul F 373 Advance, - art. no. 51050989
9.2 Cast iron door for base
(Jøtul F 371 Advance)
Black paint - art. no. 51050944
9.3 High Top
Art no. 51050934
9.4 Heat storage system
Art. no. 10026701
9.5 Outside air connection
Ø 100 mm, art. no. 51012164
9.6 Soapstone top, complete
Art. no. 22052834, BP
Art. no. 22052835, WHE
Art. no. 22052836, BLE
ENGLISH
To Next Page
Loading...
Need help?
General
