3
139473_A 9/11/12
Standards
The Jøtul F 55 wood stove has been tested and listed to:
U.S: ANSI/UL 1482-2011 and ANSI/UL 737-2011
Canada: CAN/ULC-S627-M00
Tests performed by:
ITS, Intertek Testing Services
Middleton, WI
Manufactured by:
Jøtul North America
55 Hutcherson Drive
Gorham, Maine 04038-2644
The Jøtul F 55 Carrabassett wood stove meets the U.S.
Environment Protection Agency’s Emissions limits for
wood heaters manufactured and sold after July 1, 1990.
Under specific, limited laboratory tests, this heater
has shown heat output at rates ranging from 11,600
to 30,400 BTU’s per hour. Actual heat output will vary
depending upon fuel type and quality, home design,
climate, environment, operation, and chimney function.
The Jøtul F 55 Carrabassett wood stove is only listed to
burn solid wood only. Do not burn any other fuels.
Read this entire manual before you install and use your
new Jøtul F 55 Carrabassett wood stove.
Save these instructions and make them
available to anyone using or servicing the
stove.
Check Building Codes
When installing, operating and maintaining your
Jøtul F 55 Carrabassett woodstove, follow the
guidelines presented in these instructions, and make
them available to anyone using or servicing the stove.
Your city, town, county or province may require a
building permit to install a solid fuel burning appliance.
In the U.S., the National Fire Protection Association’s
Code, NFPA 211, Standards for Chimneys, Fireplaces, Vents
and Solid Fuel Burning Appliances, or similar regulations,
may apply to the installation of a solid fuel burning
appliance in your area.
In Canada, the guideline is established by the CSA
Standard, CAN/CSA-B365-M93, Installation Code for
Solid-Fuel-Burning Appliances and Equipment.
Always consult your local building inspector or
authority having jurisdiction to determine what
regulations apply in your area.
The Jøtul F 55 Carrabassett is approved for use in mobile
homes. Install in accordance with 24 CFR, Part 3280
(HUD).
To Next Page
Loading...
Need help?
General
