Cyclone Direct / Indirect Installation Guide
7
Handling
-
tion, servicing, maintenance and repair must be carried out by a competent person.
with current I.E.E Wiring Regulations.
be installed correctly in the system. The use of an electric immersion may lead to the build up
of electrical potential in the water. This can in turn cause corrosion of the immersion. To prevent
this, ensure the immersion heater, and the hot and cold pipework are correctly bonded and
connected to the earth line.
10bar.
A thermostatic mixer should be installed in the system to prevent the risk of scalding. If there are
the cylinder
What Is Benchmark?
-
sioned and serviced in accordance with the manufacturer’s instructions by competent persons and
-
Visit www.centralheating.co.uk
HWA Charter Member
Joule™ are proud to be a charter member of the the Hot Water Association (HWA), that has been
The objectives of the HWA are “To be recognised as the leading body in domestic hot water storage
and, through cooperation and partnerships, to support, drive and promote the sustained growth
and improvement of standards within the entire domestic hot water industry”.
To Next Page
Loading...
