Joy-it Arcade-GameStation - Page 46

Ausgabe 18.01.2017 Copyright by Joy-IT 46
3
Arcade-GameStaon
7. Service
Linker Kit board with joystick
This board contains a mini-joystick with analog Y-X coordinate-output which can
control games or other controls.
 Breakout-Board with analog X/Y-output for ADC-Controller-analysis
 X/Y-Output with 2 potentiometers and one button
Linker Kit Board with 8 mm RGB-LED
Any amounts of this RGB-LEDs can be connected together. Every LED is controllable
with the integrated controller. Any colors and patterns can be created.
 8-mm-RGB-LED WS2812, lights in 16,7 million colors with 256 brightness-levels
 LED controllable by microcontroller (Arduino, Raspberry Pi, pcDuino)
 Color and brightness adjustable
 Multiple modules can be connected togehter
Linker Kit Board with switching relais
This module contains a switching relais which is controllable by one I/O-PIN.
 Breakout-Module with transistor-switching-step, LED and relais
 NO/NC-switching-contact 30 V/10 A
Linker Kit Board with OLED-Display 0,96"
It features a high contrast, a wide perspective, low power requirement, a very
compact build and it communicates over an I²C-Interface.
 OLED-Display, 128 x 64, monochrom, blue
 Communicationinterface: I
2
C, Driver: SSD1306
 Operating Voltage: 3,3–5,5 V
 Operating Temperatur: -30 to +70 °C
Linker Kit Board with slide-potentiometer
Sensitiv analog inputs between 0V and Vcc are possible with this potentiometer.
 Breakout-Board with linear slide-potentiometer, distance 40 mm
 LED controllable by another PIN