Preparation
7.08
Setting the stitch length
● 1。
● ，
。
●
●
Press key and at the same time turn the balance wheel until the
stitch setter clicks into position.
Hold down key and turn the balance wheel to and fro until the stitch
lengthrequired is shown on the scale opposite the bottom edge of
the belt guard recess.
1 2
3
1
1
2 3
7-7 2-2
2.01 （9620、9625）
Hook post, right
(
(
Clean daily, more frequently if in continuous operation
Oil level (thread lubrication/hook lubrication) daily, before use
Oil the hook daily, before use
Lubricate the bevel gears once a year
Check/adjust air pressure daily, before use
Clean air filter of air filter/lubricator when required
……………………………
…………………
…………………………………………………………
………………………………………………
…………………………………………
………………………………
Clean daily, more frequently if in continuous operation
Oil level (thread lubrication/hook lubrication) daily, before use
Oil the hook daily, before use
Lubricate the bevel gears once a year
Check/adjust air pressure daily, before use
Clean air filter of air filter/lubricator when required
……………………………
…………………
…………………………………………………………
………………………………………………
…………………………………………
………………………………
Care and Maintenance
Care and Maintenance
8 Care and Maintenance
8 Care and Maintenance
………………………………………… ， ，
（ ） ………………………………… ，
………………………………………………………，
……………………………………………………………
……………………………………………… ，
………………………………………
/
/
/
………………………………………… ， ，
（ ） ………………………………… ，
………………………………………………………，
……………………………………………………………
……………………………………………… ，
………………………………………
/
/
/
。
，。
These maintenance intervals are caculated for the average running time of
a single shift operation. If the machine is operated more than this, shorter
intervals are recommended.
。
，。
These maintenance intervals are caculated for the average running time of
a single shift operation. If the machine is operated more than this, shorter
intervals are recommended.
8.01
Checking ladjnsting the air pressure
/
8.01
Checking ladjnsting the air pressure
/
！
● ，
。
● 。
● ，。
● ， ，
。
●
●
●
●
Before operating the machine, always check
the air presure on gauge .
Gauge must show a pressure of .
If necessary adjust to this reading.
To do so, pull knob upwards and turn it so
that the gauge shows a pressure of .
1
1 6 bar
26
bar
1
1 6 bar
2
6 bar
● ，
。
● 。
● ，。
● ， ，
。
●
●
●
●
Before operating the machine, always check
the air presure on gauge .
Gauge must show a pressure of .
If necessary adjust to this reading.
To do so, pull knob upwards and turn it so
that the gauge shows a pressure of .
1
1 6 bar
2 6
bar
1
1 6 bar
2
6 bar
8-1
2-1
2.01 （9620、9625）
Hook post, right（9620、9625）
19 0* 260 6 8
Zj 96 10、9620、9625、9630
08 .0 4.2
To Next Page
Loading...