16 17
UTENSIL PRECAUTIONS
when full.
Select the desired function using the Wash Mode buttons, and then push the
(Start/Pause) button. If the is not pressed, the unit will start the wash cycle
automatically after 10 seconds.
NOTE: If no buttons are pressed after the power is turned on, the unit will
automatically go back to Standby mode after 2 minutes.
3. Pause function: During operation, user can press the [ ] key to suspend
the washing program. The [ ] indicator on the display will light up. Press
the [ ] button again to resume or cancel the pause function.
4. Switch off: Press the [ ] key to switch off the appliance directly.
Make sure that the dishware is suitable for the appliance before operation.
Following items are not suitable to be washed in the dishwasher.
1. Cutlery and utensils made of wood;
2. Delicate decorative glasses, craft and antique utensils;
3. Plastic items (unless they are marked “dishwasher safe” or equivalent;
otherwise, , consult with manufacturer’s advice);
4. Copper and tin utensils;
5. Utensils which are soiled with ash, wax, lubricating grease or ink, etc;
6. Aluminum and silver parts (Tendency to discolor and fade after number of
wash cycle);
7. Types of glass (e.g. crystal glass objects)(Tendency to turn cloudy after many
wash cycle.
USER-MAINTENANCE INSTRUCTIONS
Regular inspection and maintenance will help to prevent malfunction. Recom-
mended to look for the following points to check.
1. Overall condition
Check if the spray arm deposited with grease and lime scale. If deposit found,
add dishwasher detergent and start the [Strong wash] mode in an empty
chamber.
2. Door and door seal
Clean door rubber packing with a damp cloth regularly. Never use a steam
cleaner to clean the dishwasher. We are not liable for any consequential
damage if steam cleaner is used.
Regularly wipe the door and control panel with a damp cloth. Do not use spong-
es with a rough surface or abrasive detergents, as these could scratch the
surfaces.
3. Filtration system
The entire filtration system consists of a coarse filter, a microfilter and a flat
fine filter. The filtration system keeps large foreign objects or residues away
from the circulation system.Clean them regularly to avoid affecting the perfor-
mance of the appliance.
After each operation, check if any residue blocked by the filters and turn the
cylinder filter anti-clockwise to unlock. Take out the flat fine filter as well and
clean them under running water. After that, turn the cylinder filter clockwise
and ensure that the arrow marks are opposite to each other for proper installa-
tion.
4. Spray arm
Limescale and dirt in the rinsing water may block the nozzles or the bearing
assemblies of the spray arm. Check the outlet nozzles on the spray arm regu-
larly. Lift the spray arm upwards to detach, clean the spray arm under running
water and lock the spray arm into position. (Refer to Chapter 1 INSTALLATION
INSTRUCTIONS in case)
5. Waste water pump
Large food remnant, which is not being filtered by the filtration system, may
block the waste water pump. Rinsing water will not be pumped out and as a
To Next Page
Loading...