19 20
1. During the pulping process, please do not open the lid to prevent scalding.
2. When the room temperature is higher than 30°C, the appointment time
should not exceed 12 hours.
3. It is strictly forbidden to heat the recevier cup on an open flame or induction
cooker.
4. After the production is completed, the temperature of the receiver cup, the
pulp outlet, the mixing cup, and the mixing cup lid are higher, please do not
touch directly with your hands.
5. When there is operation in the mixing cup that needs to be discharged, please
select the speed control function on the operation interface. Discharge
directly after crushing.
6. When making drinks, please add ingredients strictly in accordance with the
recipe.
7. Do not cut off the power during automatic cleaning.
8. When making an appointment, please note that the countdown time might be
slightly different than the standard appointment time, it is a normal pheno
enon and does not affect the quality of the drink.
9. The production time displayed on the screen may deviate from the actual
production time, which is normal.
10. During the production process. Do not remove the receiver cup.
11. If the power is cut off abnormally, do not drink the prepared beverages.
12. When manually using a brush to clean the mixing cup, be careful of the
blade causing injury to your hands.
13. Please make sure that the residual water container is in place before
automatic cleaning.
14. After adding ingredients to the mixing cup, please clean up the ingredients
around the mouth of the cup to avoid being unable to close the lid and seal it.
15. Please use pure water to make drinks.
16. When making coloured ingredients, the machine may be stained.
17. This product can only be used in regions below 2000 meters above sea level.
18. This product can only be used in an environment with a temperature of
4°C-40°C.
19. Please remove pits from ingredients with pits such as date pits.
20. The working timer will be automatically adjusted as per altitude and
voltage. After cleaning, open the lid of the mixing cup to dry the water in the
air.
21. When making drinks containing rice, it is normal for the rice to stick slightly
to the mixing cup.
22. Do not touch the blade, motor and other detachable parts during product
energization and operation to avoid injury or product damage.
23. DO NOT to use this product with no load (no food in the cup) or overload (the
amount of food exceeds the rated value).
24. This product is only suitable for household use, please do not use it for
other purposes.
25. Do not insert or pull the power plug with wet hands to avoid electric shock.
When powering off, manually hold the plug to pull it out, avoid pulling the
power cord; Avoid touching the power cord with sharp edges, sharp
corners, etc. to avoid damage or leakage.
26. When using this product, place it on a stable surface. Do not place on a
sloping or unstable table. Do not operate this product on flammable mater
als such as carpet, towel, plastic, paper, etc., and keep it away from the
countertop edge to avoid product dumping or accidents.
27. The speed control function of this product is only suitable for special recipe
making.
28. During the operation process, it is strictly forbidden to move the machine to
avoid overflow of food materials, which may cause burns and electric
shocks.
29. If the power cord is damaged, in order to avoid danger, please contact the
manufacturer, its maintenance department or similar department profe
sional for a replacement.
30. When not in use, please turn off the switch and turn off the power to avoid
short circuit.
31. This product and food contact parts of the material are in line with the food
grade certification as clean, hygienic, reliable. Discard the product and its
package and submit it to a qualified department for recycling. Cut the
power cable and submit to the qualified department for recycling.
32. Turn off the power switch and disconnect the power supply before replacing
the parts or contacting the moving parts.
33. The continuous belnding time of this product shall not exceed 6 minutes
(refer to the recipe instructions and display instructions for the running
time of each program), and the machine shall be shut down for 1 minute
after each belnding; The above is one cycle. After 3 consecutive cycles of
operation, the power must be disconnected, cooling and rest for 15 minutes
before operation to ensure the life of the product.
34. Please place the machine 10cm away from any wall or obstruction to
prevent the machine or motor from stopping due to poor heat dissipation at
the air outlet.
Intake nozzle
Blade
Mixing cup
Operation
interface
Water
container
Receiver cup
Mixing cup
lid assembly
Water tank and
water tank lid
Power cord and
plug
COMPONENTS AND FUNCTIONS
• Make sure soy milk has been fully cooked before consuming.
• After making the drink, please drink it as soon as possible to maintain its
fresh taste.
• Infants, people with renal failure, and weak gastrointestinal function should
choose low-concentration soy milk or reduce drinking amount.
Tip for use
Receiver cup Water container Water tank
Filter bag
To Next Page
Loading...
Need help?
General
