Joyoung Y1-US02 User Manual

29 30
Receiver cup
and lid
Water container Water tank and
water tank lid
Mixing cup lid
The display does
not light up
The power plug not properly
plugged in
Plug the power adapter properly
If the machine has not been
operated for a long time,
change to sleep mode
Touch the button with your finger to
turn on the machine
No functional program selected
Select the corresponding function
program
The display is on
and the machine
is not working
Fault phenomenon Cause analysis Countermeasure
Fault phenomenon
Cleaning accessories
1. The above 4 parts shall be dismantled from the machine and rinsed under
tap water. Be sure not to soak the mixing cup lid in water for cleaning!
2. When the machine is interrupted in the making process due to excessive
food or abnormal power failure, the finished materials will not be automat
cally discharged after the machine starts to automatically feed water. Please
do not select all functions again, including the cleaning function! The
"Speed" function should be selected to crush and discharge the food in the
mixing cup, then the machine will enter automatic cleaning program.
3. After making the beverage, the mixing cup lid component shall be frequently
cleaned to avoid peculiar smell or bacteria. The mixing cup lid component
should be dried after cleaning to avoid water ingress.
4. After the machine parts are cleaned, it is suggested that the parts shall be
wiped or dried to be assembled as the whole machine, which shall be stored
in a dry and ventilated place.
5. After finishing the production, the water container plug shall be cleaned up
timely, to avoid residual grease or unsmooth floating.
6. The receiver cup, receiver cup lid, water tank, wanter tank lid, and water
container can be put into the dishwasher for cleaning, other accessories are
not allowed.
Occasional noise is normal
Ingredients are not
drained into the
receiver cup properly
Wastewater is not
discharged in the
water container
After power on, the whole machine is
reset, use the speed control key to
discharge the ingredients into the
receiver cup and start again
Too many or too few
ingredients
Water tank filter at the
bottom is clogged
No response to
touch
Fault phenomenon Cause analysis Countermeasure
No water is added in the
water tank or not placed in
place
Fill the water tank to the water level
mark and secure it in place
The display is on
and the machine
is not working
Leaking water in the machine
Please contact customer service
Take the filter mesh out of the water
tank and clean it, then return
Power off after 2 minutes and then
power on again
Short power-off interval, the
system is not reset
Ingredients cannot
be blended
Abnormal power
failure
Correct selection of functional
programs
Add ingredients according to the
recipes
Selected wrong function
Wrong function program
Overflow
Abnormal noise
Add ingredients according to the
recipes
Correct selection of functional programs
Too many ingredients or too
bulky ingredients
Water temperature is too low
Excessive beverage
processing time,
others are normal
Correct selection of functional programs
Use room temperature water
Wrong function program
Place receiver cup in the right place
The receiver cup is not
secured in place
Place the water container in place
The water container is not in
place
Machine running-in
No water in the
mixing cup

Joyoung Y1-US02 Specifications

General

Brand	Joyoung
Model	Y1-US02
Category	Blender
Language	English