INSTRUCTIONS MANUAL CODE 80368 REV A DEC2018 (It can be modied without notice) Page.: 12
J.P. SELECTA s.a.u. Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 93 770 08 77 Fax 34 93 770 23 62
e-mail: selecta@jpselecta.es - website: www.jpselecta.es
INSTALLATION
Put the incubator on a at horizontal, level surface, leaving a space
of about 10 cm at the back of the machine.
Do not install the incubator near sunny or heating places.
For an optimum function, the ambient temperature must not be over
30ºC.
Do not use the incubator to dry or for thermal treatment of products
which can give off vapours capable of making an explosive mixture.
Be sure that the voltage supply is the same as the one indicated on
the characteristics plate.
Do not use the equipment if it is not earthed.
If you change the plug bear in mind the following :
Blue cable: Neutral.
Brown cable: Phase.
Yellow/green cable: Earth.
OPERATION
CONTROL PANEL:
1. General switch
2. Indicator screen
3. Stop button / Start cycle
4. Reduce Value key
5. Increase Value key
6. Adjustment (change between temperature / time)
7. Safety thermostat adjustment screw.
6 5 4 3
1
2
7
To Next Page
Loading...
