JPI CUBE X Series - EMC Information; Guidance and Manufacturers Declaration - Electromagnetic Emissions

DOC. NO.: JDP-013-CUBEX
Issued Date: 2017.07.21
Revision: 2017.07.21(Rev.0)
13/54 Page
1.4 EMC Information
1.4.1 Guidance and manufacturer’s declaration - electromagnetic
emissions
The CUBE X series is intended for use in the electromagnetic environment specified below.
The customer or the user of the CUBE X series should assure that it is used in such an
environment.
Immunity test
Compliance
Electromagnetic environment -guidance
RF Emissions
EN 55011
Group 1
The CUBE X series uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment
RF Emissions
EN 55011
Class A
The CUBE X series is suitable for use in all
establishments other than domestic and those directly
connected to the public low-voltage power supplies
buildings used for domestic purposes.
The CUBE X series is suitable for use in all
establishments other than domestic establishments
and those directly connected to the public low-voltage
power supply network that supplies buildings used for
domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage
fluctuations/
Flicker emissions
IEC 61000-3-3
Complies