JPI CUBE X Series - Safety Precautions; Owners Responsibility; System Diagnostic

DOC. NO.: JDP-013-CUBEX
Issued Date: 2017.07.21
Revision: 2017.07.21(Rev.0)
9/54 Page
1.3 Safety Precautions
1.3.1 Owner’s responsibility
Do not use the system if unsafe conditions are known to exist. In case of hardware
failure that could cause hazardous conditions (smoke, fire and etc), turn the power OFF
and unplug the power cords of all subsystems.
The owner has responsible for ensuring that all system users are fully understand service
manual and other relevant literature.
1.3.2 System diagnostic
The owner is responsible for ensuring that diagnostic of system is performed every year.
Do not try to use the system if system diagnostic is fail.
The owner must run calibration software to diagnosis system every year. If the error has
detected, report detailed error to JPI HEALTHCARE field service representative.
1.3.3 Calibration
Verify the system is calibrated to ensure the optimal performances of the system.
The owner has responsibility for ensuring the system calibration when installing system
or repairing system. Using not calibrated system must be forbidden.