Chapter 4 Operation Method
64
2. Check the ship's heading angle that the gyro compass displays. Then enter the read value in
the [Gyro setting] input box.
[Information]
About how to enter a number, see “4.1.5 Number input”.
3. Make sure that the value of [Monitor] field is the almost same value as the read value of gyro
compass. If not, repeat Step 2.
[Information]
The value of [Monitor] field is obtained by converting the got ship's heading angle from the gyro
compass by the value of [Gyro setting] field. Therefore, the value of [Monitor] field should be the
almost same value as the read value of gyro compass.
Figure 4-57 Setting the ship's heading angle
Enter the read value of gyro
compass.
This value displays the got ship's
heading angle from the gyro
compass in real time.
To Next Page
Loading...
