S-13
2.13 Display Radar Trails [TRAILS]
Changing the length of the trail
Procedures
1 Press the [TRAILS] key.
Values of the length of the radar trail are switched.
Erasing Trails Data
Procedures
1 Press the [TRAILS] key for 5 seconds.
All the saved trails data will be erased. The system starts plotting trails in initial state.
If [TRAILS] key is pressed for 2 seconds, the RADAR Trails Setting menu is opened.
Furthermore, data will be erased if it continues pressing.
Changing Motion Mode of Trails (Trails mode)
Procedures
1 Put the cursor on radar trails display true T / relative R switching,
and press the [ENT] key.
The trails motion modes are switched.
If true motion (TM) mode is selected in azimuth display mode, only the true motion trails mode is
available.
To Next Page
Loading...
