- iv -
WARNING
Never carry out internal inspection or repair work of the
equipment by users.
Inspection or repair work by unauthorized personnel may
result in fire hazard or electric shock.
Ask the nearest branch, business office or a dealer for
inspection and repair.
Turn off the main power before maintenance work.
Otherwise, an electric shock may result.
Turn off the main power before cleaning the equipment.
Especially, make sure to turn off the indicator if a rectifier
is used. Otherwise, equipment failure, or death or
serious injury due to electric shock may result, because
voltage is outputted from the rectifier even when the
radar is not operating.
Turn off the main power if you need to be near the
scanner unit for maintenance or inspection purposes.
Direct exposure to electromagnetic waves at close range
in death or serious injury.
Turn off the main power source before starting
maintenance.
Otherwise, an electric shock or injury may be caused.
When conducting maintenance work, make sure to turn
off the power and unplug the power line of the processor
so that the power supply to the equipment is completely
cut off.
Some equipment components can carry electrical current
even after the power switch is turned off, and conducting
maintenance work without unplugging the power
connector may result in electrocution, equipment failure,
or accidents.
To Next Page
Loading...
Need help?
General
