JRC JMA-9123-7XA - C.2 PI

JMA-9100 Instruction Manual > C.Menu Index > C.2 PI
C－5
C
C.2 PI
├ 1. Display for All Lines - - - - - - - - - - - - - - - - - - - - - - - - - - section 4.1.4.3 on page 4-9
├ 2. Operation Mode - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -page 4-10
│├All
│├Individual
│├Track
│└Equiangular
├ 3. Control
1 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
page 4-11
│├All:All
2
│├Individual:Sequential
│├Individual:Index Line 1
│├Individual:Index Line 2
│├Individual:Index Line 3
│├Individual:Index Line 4
│├Individual:Index Line 5
│├Individual:Index Line 6
│├Individual:Index Line 7
│├Individual:Index Line 8
│├Track:Group 1
│├Track:Group 2
│├Track:Group 3
│├Track:Group 4
│├Equiangular:Group 1
│├Equiangular:Group 2
│├Equiangular:Group 3
│└Equiangular:Group 4
├ 4. Floating - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
page 4-11
├ 5. Heading Link - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -page 4-11
├ 6. Next
├ 8. Press EBL Dial to Control PI#
3
├ 9. Press VRM Dial to Move End Point#
ii
├ 1. Range Scale Link - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -page 4-12
├ 2. Reference Bearing
i- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
page 4-12
│├All:True
4
│├All:HL
│├Individual:True
│├Individual:HL
│├Individual:Index Line 1
│├Individual:Index Line 2
│├Individual:Index Line 3
│├Individual:Index Line 4
│├Individual:Index Line 5
│├Individual:Index Line 6
│├Individual:Index Line 7
│├Individual:Index Line 8
│├Track:True
│├Track:HL
│├Track:Index Line 1
│├Track:Index Line 2
│├Track:Index Line 3
│├Track:Index Line 4
│├Track:Index Line 5
│├Track:Index Line 6
│├Track:Index Line 7
│└Track:Index Line 8
├ 3. Operation Area - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
page 4-13
├ 4. Display for Individual Line - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -page 4-13
1.The setting items are determined by the setting of Operation Mode.
2.Operating Mode: Control
3.Displayed only when "3. Control" is Individual.
4.Operating Mode: Reference Bearing