JRC JMA-9932-SA User Manual

1
Click I
GZ
I
The GUARD ZONE Menu will appear.
Select
"ON" of
'GUARD
ZONE1" to
create
a
guard
zone 1 and
"GUARD
ZONE2" to create a
guard
zone 2.
When Guard Zone 1 and 2 are set.
"ON"
will
sel.
aaaaaaaaooaaaaaaaaaaooaaaaaaaaaaoaaaaaa
Set Guard Zones
[GUARD
ZONE]
A fan-shape
guard
zone
can be set up
to keep a watch over the intrusion
of other ships
or targets,
or
to
automatically acquire other
ships that have intruded into the zone.
By left
clicking
the
"G21,
2" section on
the
screen,
it is
possible
to
set on or ofi.
In this
case, the zone that
was set the
previous
time will be turned on.
tll
Creation of Fan-shaped Guard
zone
GUARD
ZONE
l.GUARD
ZONEI(GZI)
E
opp
noH
2.GUARD ZONE2(GZz)
Eopr noN
3.
(0.5NM-32NM)
4, I MAKE
GZ2
oFNM:5ZNMt-
s.SET ACQ AUTO KEY
o.
.
EXIT
3 Click
ilttAKE
GA to create GUARD
zoNE1.
4
clicr
llvlEre
C22lto
create
GUARD
zoNE2.
The
cursor
will move to the
echo display
section.
Note:
Guard
Zones I or 2 can
be set
in any area within
a
range of
0.5 to 32
NM.
Use the
IVRMI
and
[EBL]
knobs to
place
VRM and
EBL
over
the starting
point
of the
guard
zone, then
left
click
the
cursor.
The starting
point
of the
guard
zone
will
be set.
Move the EBL to make fan-shaped zone enclosed by the
current cross cursor
position.
Left+lick
when
a desired
guard
zone is made.
The
shape of the
guard
zone will
be set up.
(The
width of a
guard
zone is fixed to 0.5NM).
3-61

JRC JMA-9932-SA Specifications

General

Brand	JRC
Model	JMA-9932-SA
Category	Marine Radar
Language	English