JRC JMR-9282-S - Page 109

2-51 Chapter 2 System Configuration
Table 2.4.24 RIF I/O specifications 4
Label Name Pin
Signal
Name
I/O Specification Detail
J835 GYRO I/F - GYRO I/F I/O
Gyro Interface
Circuit
Internal wiring
J836 EX_OUT
1
VD_OUT+ OUT
0 to -2.6V
Output Z : 50 ohm
50dB / V
See
Fig. 2.4.22 RIF
VD_OUT detail
2
VD_OUT- OUT
3
TRG_OUT+ OUT
0 to 4V
Output Z : 50 ohm
Pulse width : 1us
See
Fig. 2.4.23 RIF
TRG_OUT detail
4
TRG_OUT- OUT
5 BP_OUT+ OUT
Open Collector
Output
5V, 1k ohm Pull-up
is recommended.
See
Fig. 2.4.24 RIF
BP BZ_OUT
detail
6 BP_OUT- OUT
7 BZ_OUT+ OUT
8 BZ_OUT- OUT
9 GND - GND -
10 N.C. - N.C. -
J837
AC_SC_IN
(DC48V)
-
AC_SC_IN
(DC48V) - Power Supply Unit Internal wiring
TB838
AC_MTRPWR
(AC100/220V)
1
U OUT
100-220Vac ,
50/60Hz,
Single phase
Depends on
PSU AC IN
2
V OUT
J839
DC_SC_IN
(DC24V PSU)
-
DC_SC_IN
(DC24V PSU)
- Power Supply Unit Internal wiring
TB840
DC_MTRPWR
(DC24V MTR)
1 + OUT
24Vdc PSU DC IN
2 - OUT