Need help?Do you have a question about the JRC NRD-515 and is the answer not in the manual?
Remove top cover, drill holes, and remove specific circuit board components.
Install option plug-in units and solder necessary wires and coax cables.
Mount the top and bottom covers of the NRD-515 receiver.
Power on, tune receiver to 00.0 kHz for maximum S-meter reading.
Adjust L3 and L9 for maximum S-meter reading and mount the top cover.
Defines bandwidths (300 Hz to 4.5 kHz) and shape factor (1/1.7) with monitor switch ON.
Defines bandwidths (500 Hz to 6 kHz) and shape factor (1/2.5) with monitor switch OFF.
Steps for tuning a station using the PLAM detector, including switch positions and controls.
Remove top cover, drill holes, and remove specific circuit board components.
Install option plug-in units and solder necessary wires and coax cables.
Mount the top and bottom covers of the NRD-515 receiver.
Power on, tune receiver to 00.0 kHz for maximum S-meter reading.
Adjust L3 and L9 for maximum S-meter reading and mount the top cover.
Defines bandwidths (300 Hz to 4.5 kHz) and shape factor (1/1.7) with monitor switch ON.
Defines bandwidths (500 Hz to 6 kHz) and shape factor (1/2.5) with monitor switch OFF.
Steps for tuning a station using the PLAM detector, including switch positions and controls.
General| IF Rejection | 70 dB |
|---|---|
| IF Frequencies | 1st IF: 70.455 MHz, 2nd IF: 455 kHz |
| Type | Communications Receiver |
| Modes | AM, SSB, CW |
| Sensitivity | 0.5 μV for 10 dB S/N |
| Image Rejection | 70 dB |
| IF Bandwidths | 6.0 kHz |
| Power | 100-240 VAC |
To Next Page
