Juiceman JMB1000 - Preparing Fruits and Vegetables; Assembling and Using Your Juicer; Assembly and Operation Steps

7
6
PREPARING FRUITS AND VEGETABLES FOR JUICING
h
i
•
2
l
o
w
•
1
o
f
f
•
0
Wash fruits and vegetables thoroughly before juicing.
TIP: Use a natural bristle brush and biodegradable cleaner to help
remove pesticide residue.
h
i
•
2
l
o
w
•
1
o
f
f
•
0
Trim any bruised or discolored sections of fruit and vegetables.
Remove and discard outer leaves.
h
i
•
2
l
o
w
•
1
o
f
f
•
0
You can juice with the skin on but the skin of citrus fruits can taste
bitter so we recommend removing their peel.
h
i
•
2
l
o
w
•
1
o
f
f
•
0
Remove pits and large seeds from fruits, including apricots,
cherries, nectarines, mangoes, peaches, plums and melons.
h
i
•
2
l
o
w
•
1
o
f
f
•
0
Be sure all parts of the juicer are clean and dry. See CARING FOR
YOUR EXPRESS WHOLE JUICER section of this manual.
ASSEMBLING YOUR WHOLE JUICER
Important: Always make sure juicer is unplugged before
starting to assemble.
Step 1: Place cup on a stable surface
with the open side up.
Step 2: Add ingredients into your blending cup! We
recommend adding ingredients in the following order:
1. Ice
2. Veggies
3. Fruits
4. Powders, seed, nuts
5. Liquids
Caution: Do NOT fill past max fill line
Step 3: Holding the cup in one hand, screw the blade
base onto the cup, turning clockwise to tighten.
Important: Make sure the base is screwed on tightly to prevent leaks.
Caution: Handle blade base carefully as blades are sharp.
Step 4: Turn the cup upside down and place it onto
the motor base.
Step 5: Turn blade base and cup clockwise to lock
and start blending. The juicer starts right when you
twist it!
Step 6: Once you have reached your desired
consistency, stop the appliance by turning the
cup assembly counterclockwise to unlock. Once
unlocked, pull the cup straight up to remove.
Note: Make sure to twist the cup and blade assembly together when
unlocking. Do not twist the cup off the blades. This will cause leaking.
Step 7: Flip the cup upright. Twist counterclockwise
to remove the blade base from the cup. Use the
finger tabs located on the interior of the bottom of
the blade base to help when twisting.
Step 8: Place the travel lid onto the cup, turning
clockwise to close and enjoy!
Step 9: Wash all parts as instructed in CARING FOR
YOUR EXPRESS WHOLE JUICER
DISASSEMBLING YOUR JUICER
Step 1: Unplug your juicer
Step 2: Pull up on the cup to remove it from the base