Safety Information
NOTE: Read these instructions completely before installation and use. Always disconnect
all power from electronic components during installation and maintenance except as
specifically instructed for safely testing functionality. Ensure all wiring is properly grounded
and protected. The underground cable must be encased in a protective tube or conduit
(not included).
NOTE: Any large moving object made of ferromagnetic metal—iron, steel, nickel, etc.
—can potentially activate this device. Depending upon its placement and settings, such
objects may include riding lawnmowers, ATVs, bicycles, and even children’s tricycles.
Exercise caution during setup, test any such objects that might be used nearby, and
provide proper training and warnings to all persons who will be passing through the gate
controlled by this device. Ensure they understand the potential risks, safe operation
procedures, and how to avoid potential entrapment and pinch points in the case of an
emergency or malfunction.
● ONLY install and use this device in accordance with these instructions, the separate
instructions for your gate opener, and all applicable local and national laws and
regulations. Adding instructional or warning signage may be necessary in your area or
if there will be pedestrians or children nearby during use. Failure to configure and use
this device properly may result in serious property damage and severe personal injury.
● ONLY use this device for its intended purpose, opening and closing a single sliding
gate or swing gate to facilitate vehicular traffic. Pedestrians should be warned about
the device, kept away when vehicles are nearing its sensing range, and provided with
a separate access point far enough away to ensure they never come into contact with
the moving gate.
● DO NOT install this device in a location where passing traffic or the gate itself might
activate it. Installing it in a location 13 feet (4 m) away from such traffic and from the
gate itself is highly recommended.
● DO NOT use this device in locations where its accidental activation might release
children, pets, or livestock without their caretaker’s knowledge. In such settings, a
separate remote or keypad control can be used on the enclosed side of the gate and
the exit wand on the opposite side, but it must be carefully configured and protected
to eliminate any possibility of accidental activation.
● DO NOT install this device in any area prone to flooding or exposed to flammable or
explosive fumes.
● DO NOT tamper with or modify this device. Modifying its components or settings can
compromise its functionality and may lead to malfunctions and/or cause safety hazards.
1
Warning!
To Next Page
Loading...