Need help?Do you have a question about the JUKI HZL-27Z and is the answer not in the manual?
Adjust height using screw A, turning clockwise for low, counter-clockwise for high.
Loosen screw 'A' fixing needle bar to adjust needle height.
Adjust presser bar by sliding vertically after loosening screw A.
Turn alignment screw A clockwise (right) or counter-clockwise (left).
Ensure 0-0.1 mm clearance between needle and shuttle point at max zigzag.
Loosen bolt A, move support unit B to adjust needle clearance.
Verify feed dog moves horizontally 0-0.5 mm when needle reaches highest position.
Adjust height using screw A, turning clockwise for low, counter-clockwise for high.
Loosen screw 'A' fixing needle bar to adjust needle height.
Adjust presser bar by sliding vertically after loosening screw A.
Turn alignment screw A clockwise (right) or counter-clockwise (left).
Ensure 0-0.1 mm clearance between needle and shuttle point at max zigzag.
Loosen bolt A, move support unit B to adjust needle clearance.
Verify feed dog moves horizontally 0-0.5 mm when needle reaches highest position.
General| Type | Electronic Sewing Machine |
|---|---|
| Stitch Options | 27 |
| Maximum Stitch Width | 5 mm |
| Maximum Stitch Length | 4 mm |
| Weight | 5.5 kg |
| Sewing Speed | 750 stitches per minute |
| Needle Threader | Yes |
| Stitch Length Adjustment | Yes |
| Stitch Width Adjustment | Yes |
| Reverse Stitch | Yes |
| Free Arm | Yes |
| Buttonhole Styles | 1 |
To Next Page
