K
Kim CoxAug 8, 2025
What to do if Julabo Fan shows a low level alarm?
- AAlex RobinsonAug 8, 2025
If your Julabo Fan displays a low level alarm, switch the unit off using the mains switch, refill the bath fluid, and then switch it back on.
To Next PageTo Next PageWhat to do if Julabo Fan shows a low level alarm?
If your Julabo Fan displays a low level alarm, switch the unit off using the mains switch, refill the bath fluid, and then switch it back on.
What to do if tube breakage occurred in Julabo Fan?
If tube breakage has occurred in your Julabo Fan (due to insufficient bath fluid caused by pumping-out), replace the tubing and refill the bath liquid.
What to do for configuration error on Julabo Fan?
Press the key for a non-recurring, automatic change of the configuration.
Describes the circulator's operation, microprocessor technology, PID control, and features like ATC and RS232 interface.
Detailed technical specifications for various circulator models, including dimensions, power, and temperature ranges.
Explains the meaning of warning symbols (exclamation mark) and signal words (Warning, Caution, Notice).
Provides essential safety recommendations for connecting the unit, power supply, and placement.
Details the front and rear views of the circulator, identifying controls, display, and connectors.
Provides instructions on placing the unit, ventilation requirements, and initial setup after transport.
Instructions for correctly connecting the unit to the power supply, emphasizing safety precautions.
Details the procedure for switching the circulator on and off, including self-test and operating modes.
Step-by-step guide to powering on the circulator, including self-test and initial display.
Explains how to directly set a single working temperature and perform adjustments using the keypad.
Describes how to use the T menu to adjust and utilize three pre-set working temperatures.
Details the function and setting of the excess temperature protection feature to prevent overheating.
Explains the low fluid level warning system and the subsequent shutdown procedure to protect the unit.
Describes how to configure the system to switch between warning signals and automatic shutdown.
Explains how to set warning limits for temperatures above and below the setpoint.
Guides on adjusting the pump capacity and pressure for internal or external circulation applications.
Lists error codes, their meanings, and troubleshooting steps for various operational issues.
General