Julabo FP40-MC - User Manual

Questions and Answers

D
Darrell KramerAug 8, 2025
What to do if the Julabo FP40-MC Air Conditioner cooling compressor has overload protection?
- J
  jacobschristineAug 8, 2025
  If the cooling compressor has overload protection, it could be due to several reasons: poor air circulation, small distance to walls, dirt accumulated on condenser, high ambient temperature, or frequent on/off cycles. To resolve this, ensure proper air circulation, increase the distance to walls, clean the condenser, reduce the ambient temperature, and avoid short switch-off intervals.
U
ucollinsAug 14, 2025
What to do if Julabo FP40-MC Air Conditioner shows a warning without a complete shutdown?
- P
  patrick71Aug 14, 2025
  If the Julabo Air Conditioner shows a warning without a complete shutdown, it could be due to several reasons. The circulator may be operating without enough bath fluid, a tube breakage may have occurred, or the float may be defective. Replenish the bath tank with the bath fluid. If there was tube breakage, replace the tubing and replenish the bath tank with the bath fluid. If the float is defect, it should be repaired by authorized JULABO service personnel. Also, reconnect the cable or eliminate the short-circuit.
R
Rachel Lamb DDSAug 21, 2025
What to do if my Julabo FP40-MC's early warning system signals a critical fluid level?
- S
  Sean BarajasAug 21, 2025
  If the early warning system for low level signals a critical fluid level, replenish the bath tank with the bath fluid.
H
Heather RobinsonAug 26, 2025
What to do if Julabo Air Conditioner shows excess temperature alarm with a complete shutdown?
- F
  flynnkarenAug 27, 2025
  If there is an excess temperature alarm with a complete shutdown of the main functional elements, clean the air-cooled condenser.
C
Christy YoungSep 2, 2025
What to do if Julabo FP40-MC Air Conditioner displays special message 'CONFIGURATION ERROR'?
- S
  Suzanne GrantSep 2, 2025
  If the Julabo Air Conditioner displays the message 'CONFIGURATION ERROR', press enter to automatically perform a single modification of the configuration.