Julabo F25-MC - User Manual

Questions and Answers

K
Kevin ParkerAug 2, 2025
What to do if the Julabo F25-MC Air Conditioner cooling compressor has overload protection?
- K
  Kyle RussoAug 2, 2025
  If the cooling compressor has overload protection, it could be due to several reasons: poor air circulation, small distance to walls, dirt accumulated on condenser, high ambient temperature, or frequent on/off cycles. To resolve this, ensure proper air circulation, increase the distance to walls, clean the condenser, reduce the ambient temperature, and avoid short switch-off intervals.
K
Katherine BurkeAug 8, 2025
What to do if Julabo Air Conditioner shows a warning without a complete shutdown?
- E
  eric75Aug 8, 2025
  If the Julabo Air Conditioner shows a warning without a complete shutdown, it could be due to several reasons. The circulator may be operating without enough bath fluid, a tube breakage may have occurred, or the float may be defective. Replenish the bath tank with the bath fluid. If there was tube breakage, replace the tubing and replenish the bath tank with the bath fluid. If the float is defect, it should be repaired by authorized JULABO service personnel. Also, reconnect the cable or eliminate the short-circuit.
V
Victoria MilesAug 14, 2025
What to do if my Julabo F25-MC's early warning system signals a critical fluid level?
- S
  Samantha MartinezAug 15, 2025
  If the early warning system for low level signals a critical fluid level, replenish the bath tank with the bath fluid.
C
Charles KiddAug 20, 2025
What to do if Julabo F25-MC shows excess temperature alarm with a complete shutdown?
- M
  mitchellrebeccaAug 20, 2025
  If there is an excess temperature alarm with a complete shutdown of the main functional elements, clean the air-cooled condenser.
W
Whitney GravesAug 26, 2025
What to do if Julabo F25-MC displays special message 'CONFIGURATION ERROR'?
- C
  Christopher SimmonsAug 26, 2025
  If the Julabo Air Conditioner displays the message 'CONFIGURATION ERROR', press enter to automatically perform a single modification of the configuration.