the valid safety instructions for workplaces must be followed.
• Only connect the unit to a power socket with an earthing contact (PE –
protective earth)!
• The power supply plug serves as a safe disconnecting device from the
line and must always be easily accessible.
• Place the unit on an even surface on a base made of nonflammable
material.
• Do not stay in the area below the unit.
• Make sure you read and understand all instructions and safety
precautions listed in this manual before installing or operating your unit.
• Do not touch the immersion probe if it is frosted.
• Do not bend the tube connection of the immersion probe
• Keep the air intake and exhaust grids free of obstructions. (Maintain a
sufficient distance from all surrounding surfaces!)
• Do not move the unit from the position where it was set up during
operation.
• Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or
before moving the unit.
• Always turn off the unit and disconnect the mains cable from the power
source before cleaning the unit.
• Transport the unit with care.
• Sudden jolts or drops may cause damage in the interior of the unit.
• Observe all warning labels.
• Never remove warning labels.
• Never operate units with damaged mains power cables.
• Repairs are to be carried out only by qualified service personnel.
To Next Page
Loading...
