• The ventilation grid (7) is detached by unscrewing the four
mouting screws (FT900).
• Clean the ribbed condensor with a vacuum cleaner.
• Replace the hood or the ventilation grid.
• Switch on the unit.
Clean the outside of the unit using a wet cloth and low surface
tension water.
Repairs
Before asking for a service technician or returning a JULABO
instrument for repair, please contact an authorized JULABO
service station.
When returning the unit:
• Clean the unit in order to avoid any harm to the service
personnel.
• Attach a short fault description.
• During transport the unit has to stand upright. Mark the
packing correspondingly.
• When returning a unit, take care of careful and adequate
packing.
• JULABO is not responsible for damages that might occur
To Next Page
Loading...
