4
9.4.4. Off-Mode .............................................................................................................. 46
9.4.5. ActVar - actuating variable ................................................................................... 47
9.4.6. Setting of clock and date ...................................................................................... 48
9.4.7. Language ............................................................................................................. 48
9.4.8. Unit ....................................................................................................................... 48
9.4.9. Program type ........................................................................................................ 48
9.4.10. Reset ............................................................................................................... 48
9.5. Control ...................................................................................................................... 49
9.5.1. Control internal / external .................................................................................... 51
9.5.2. Selftuning ............................................................................................................. 52
9.5.3. Dynamik intern ..................................................................................................... 52
9.5.4. CoSpeed - extern ................................................................................................. 53
9.5.5. Control parameters – internal/external ................................................................. 53
9.6. Serial Interface .......................................................................................................... 55
9.7. ATC Absolute Temperature Calibration, 3-point calibration ...................................... 56
9.7.1. ATC Fühler - intern / extern .................................................................................. 59
9.7.2. ATC Status - yes / no ........................................................................................... 59
9.7.3. Type 1 -/ 2 -/ 3 point ............................................................................................ 59
9.7.4. Example: 3-point calibration for internal control .................................................. 60
9.8. Limits ........................................................................................................................ 62
9.8.1. Limits for internal control and external control ...................................................... 63
9.8.2. Limits for external control ..................................................................................... 64
9.9. Analog inputs/outputs ............................................................................................... 65
9.9.1. Control connector ................................................................................................. 69
9.9.2. Outputs of the connector - REG+E-PROG ........................................................... 70
9.9.3. Input of the connector - REG+E-PROG ............................................................... 71
9.9.4. External Stand-by input ........................................................................................ 73
9.9.5. Alarm-output ......................................................................................................... 74
10. Troubleshooting guide / Error messages....................................................................... 75
11. Electrical connections .................................................................................................... 78
12. Remote control .............................................................................................................. 81
12.1. Setup for remote control ........................................................................................... 81
12.2. Communication with a PC or a superordinated data system .................................... 81
12.3. List of commands ...................................................................................................... 82
12.4. Status messages ...................................................................................................... 86
12.5. Error messages......................................................................................................... 86
13. Installation of electronic module with analog connectors .............................................. 87
14. JULABO Service – Online remote diagnosis ................................................................. 88
15. Cleaning / repairing the unit .......................................................................................... 89
To Next Page
Loading...
Need help?
General
