-11-
STEP 10
STEP 10
10-1. Bring up the tank housing and rest it on the post plate.
10-2. Connect the regulator to the gas cylinder and tighten it with adjustable
wrench.Conduct a gas leakage test as described earlier in this manual.
10-3. Put gas cylinder on the stand.
Trouble Shooting
Problem Possible cause
What you can do
(if these do not work,
contact an authorised
technician)
What ONLY an
authorised
service
technician can
do
Burner will not light Gas valve may be OFF
Tank fuel empty
Opening blocked
Loose connections
Low gas pressure
Thermocouple bad
Not in correct location
Turn the gas valve ON
Check all fittings
Replace cylinder with a new
cylinder
Refill gas cylinder
Refill gas cylinder
Remove and clean
Replace thermocouple
Burner will not stay
on
Loose connections
Thermocouple bad
Gas leak in line
Lack of fuel pressure
Tank near empty
Tighten connections
Check connections
Clean dirty area
Replace
thermocouple
Burner flame is low Supply hose is bent or
twisted
Straighten hose and perform leak
test on hose
Emitter glows
uneven
Low gas pressure
Base is not on a level
surface
Replace cylinder with a new
cylinder
Place heater on a level surface
Thick black smoke Blockage in burner Turnoff the heater and let it cool. Remove blockage and
clear burner inside
and outside
Carbon build-up l Dirt or film on reflector
and flame screen
Clean reflector and flame screen
Regulator
Gas cylinder
To Next Page
Loading...