Jump n Carry JNC660 - User Manual

12 Volt Power Supply & Jump Starter
Charge the unit for 24 hours through the built-in charger upon opening the box,
charge after every use and charge before extended storage.
Pb
CONTAINS SEALED LEAD ACID BATTERY.
BATTERY MUST BE RECYCLED.
WARNING
Read these instructions completely before using the Jump-N-Carry and save them for
future reference. Before using the Jump-N-Carry to jump start a car, truck, boat or to
power any equipment, read these instructions and the instruction manual/safety
information provided by the car, truck, boat or equipment manufacturer. Following all
manufacturers’ instructions and safety procedures will reduce the risk of accident.
Working around lead-acid batteries may be dangerous. Lead-acid batteries release
explosive gases during normal operation, charging and jump starting. Carefully read and
follow these instructions for safe use. Always follow the specific instructions in this
manual and on the Jump-N-Carry each time you jump start using the Jump-N-Carry.
All lead-acid batteries (car, truck and boat) produce hydrogen gas which may violently
explode in the presence of fire or sparks. Do not smoke, use matches or a cigarette
lighter while near batteries. Do not handle the battery while wearing vinyl clothing
because static electricity sparks are generated when vinyl clothing is rubbed. Review all
cautionary material on the Jump-N-Carry and in the engine compartment.
Always wear eye protection, appropriate protective clothing and other safety equipment
when working near lead-acid batteries. Do not touch eyes while working on or around
lead-acid batteries.
Always store clamps in their holsters, away from each other or common conductors.
Improper storage of clamps may cause the clamps to come in contact with each other,
or a common conductor, causing the battery to short circuit and generate high enough
heat to ignite most materials.
Use extreme care while working within the engine compartment, because moving parts
may cause severe injury. Read and follow all safety instructions published in the vehicle's
Owner's Manual.
While the battery in the Jump-N-Carry is a sealed unit with no free liquid acid, batteries
being jump started with the Jump-N-Carry unit likely contain liquid acids which are
hazardous if spilled.
Failure to follow instructions may
cause damage or explosion,
always shield eyes. Read entire
instruction manual before use.
WARNING
WARNING
This product can expose you to lead, which is known to the
State of California to cause birth defects or other reproductive
harm, and Vinyl-Chloride, Styrene and Acrylonitrile, which are
known to the State of California to cause cancer. For more
information go to www.P65Warnings.ca.gov

Summary

Safety Information

General Safety Warnings

Read instructions, shield eyes, and handle batteries safely to prevent accidents.

Battery Hazards

Lead-acid batteries release explosive gases; avoid sparks, fire, and static electricity.

Product Features

Battery Status Gauge

Recharging Procedures

Jump Starting Instructions

12 Volt DC Power Usage

Performance and Temperature Factors

Troubleshooting and FAQs

Unit Not Holding Charge

Perform a load test after charging to check battery health.

Ideal Use Case

Best for providing an extra boost to vehicles.

Recharge Frequency

Recharge after every use to maximize battery life.

Recharging via Vehicle Alternator

Not recommended; can overcharge and void warranty.

Battery Testing Procedure

Storage Guidelines

Battery Replacement and Disposal

Limited Warranty Information

Warranty Service and Registration

Return defective items or send to Clore Automotive for service. Register online.

Jump n Carry JNC660 Specifications

General

Output Voltage	12V
Peak Amps	1700A
Cranking Amps	425A
Weight	18 lbs
Clamps	Heavy-Duty
Warranty	1 Year
Battery Type	Lead Acid
Cables	2 AWG