Note: The following steps (15-16) should be completed whilst the net is laid out on the trampoline
bed.
15. Insert the fiberglass rods into the sleeve sewn on the top of the safety net (N). Long
Fiberglass Rods for long sides (T), Short Fiberglass Rods for short sides (U).
Note: Make sure that the opening of the net (the zipper) is placed in the middle of the long side of
the trampoline. Align the logo on the net with the logo on the pad.
13
16. After inserting the fiberglass rods into the safety net both the long sides and short sides, connect
the short side to the long side with the corner fiberglass rod connector (V).
Push buttons need to be inserted into the corner pieces. Press the ends of the push button together
and push it all they way to the end of the corner piece, making sure that the button pops out through
the hole.
17. Connect the fiberglass rod to the top of the poles by clicking it into the pole caps (S) at the top of
the enclosure poles. Repeat this step for all 12 poles.
To Next Page
Loading...
