20. Tie the end of cord to the last D-ring that it reaches. Make sure that the enclosure net is attached
to every D-ring on the jumping mat.
STEP 7: ASSEMBLE THE LADDER
21. Place the two frame leg (1) on a clear area.
Then, place one of the ladder steps (2) onto the
bottom of each frame leg.
Next, slide the step up until the top bolt holes of the
legs and step lineup.
Note: Make sure the checkered pattern of step is
facing up.
22. Insert two screws (Y4) (3) through the ladder
step (2) and frame legs (1). Then, tighten one
dome nut (Y4) on the back of each screw. Repeat
to assemble the second ladder step.
23. Place the lower frame base (6) on to the ladder
frame legs (1), making sure to align the screw
holes. Then, secure using screws (Y5) on each
side of the frame.
24. Test the steps to make sure they are strong.
Find the doorway to your safety net. Lift up your
safety pads and place the hooks of the ladder over
top rail of the trampoline. Pull the ladder out from
the trampoline by its base to make sure it touches
the ground as far away from the trampoline frame
as possible.
15
To Next Page
Loading...
