JUNCTEK
JDS8000 Series User’s Manual
Waveform: Click on the waveform type, the “Waveform Type” pop-up box will
pop up, select the corresponding waveform. As shown in Figure 3-9-19 below.
Modulation switch: Click the modulation button to turn on the modulation
function. When the modulation function is turned on for the CH1, the
modulation button is yellow; when the modulation function is turned on for the
CH2, the modulation button is blue; when the modulation function is turned off,
the modulation button is gray. As shown in Figures 3-9-20 and 3-9-21 below.
AM: After the modulation function is enabled, click the modulation type to
select AM; in AM, you can modify the modulation frequency, modulation depth,
signal source, and modulation wave. As shown in Figure 3-9-22 below.
FM: After the modulation function is enabled, click the modulation type to
select FM; in FM, you can modify the modulation frequency, frequency
deviation, signal source, and modulation wave. As shown in Figure 3-9-23
below.
PM: After the modulation function is enabled, click the modulation type to
select PM; in the phase modulation, you can modify the modulation frequency,
phase deviation, signal source, and modulation wave. As shown in Figure
3-9-24 below.
ASK: After the modulation function is enabled, click the modulation type to
select ASK; in ASK, you can modify the rate, ASK amplitude, signal source,
and polarity. As shown in Figure 3-9-25 below.
FSK: After the modulation function is enabled, click the modulation type to
select the FSK; in FSK, you can modify the rate, frequency hopping, signal
source, and polarity. As shown in Figure 3-9-26 below.
PSK: After the modulation function is enabled, click the modulation type to
select the PSK; in PSK, you can modify the rate, PSK phase, signal source,
and polarity. As shown in Figure 3-9-27 below.
Pulse: After the modulation function is enabled, click the modulation type to
select the pulse; in the pulse, you can modify the pulse period, pulse width,
and pulse wave inversion. As shown in Figure 3-9-28 below.
Burst: After the modulation function is enabled, click the modulation type to
select the burst; in the burst, you can modify the number of pulses, idle, trigger
source, and polarity. As shown in Figure 3-9-29 below.
To Next Page
Loading...