JUNCTEK JDS8080 User Manual

Lists the detailed technical specifications for the JDS8000 series signal generator.

Provides a comprehensive overview of the front panel controls and indicators.

Provides a comprehensive overview of the rear panel connectors and ports.

Provides an overview of the instrument's display interface layout.

Explains the soft key menu, output status, waveform display, and parameter fields.

Guides on setting Frequency, Amplitude, Offset, Duty Cycle, and Phase via the display.

Guides on powering on the instrument and performing initial checks.

Explains how to output basic waveforms like sine, square, triangle, and pulse.

Procedures for setting frequency, amplitude, and offset parameters.

Covers the interface and settings for various modulation modes.

Details the AM modulation mode, including carrier selection and parameter setup.

Setting carrier waveforms, modulation frequency, and depth for AM.

Details the FM modulation mode, including carrier selection and parameter setup.

Setting carrier, frequency, and deviation for FM modulation.

Details the PM modulation mode, including carrier selection and parameter setup.

Setting carrier, frequency, and phase deviation for PM modulation.

Details the ASK modulation mode, including carrier selection and parameter setup.

Setting polarity, rate, amplitude, and source for ASK modulation.

Details the FSK modulation mode, including carrier selection and parameter setup.

Setting polarity, rate, hopping frequency, and source for FSK modulation.

Details the PSK modulation mode, including carrier selection and parameter setup.

Covers the interface and settings for sweep mode operations.

Covers the interface and settings for voltage control mode operations.

Covers the interface and settings for measurement mode operations.