JUNCTEK
JDS8000 Series User’s Manual
Main function operation
Frequency: Click on the frequency value to make the cursor select the digit.
You can press the left and right direction keys to change the digit and use the
knob to adjust the value. Click the frequency text or press and hold the
frequency value, and the "Input Frequency" pop-up box pops up, input the
corresponding value. As shown in Figure 3-9-12 below.
Frequency unit: press and hold the frequency unit, the "Hz, kHz, MHz, mHz,
uHz" frequency unit will pop up, select the corresponding frequency unit. As
shown in Figure 3-9-13 below.
Amplitude: Click the amplitude value to make the cursor select the digit. You
can press the left and right direction keys to change the digit and use the knob
to adjust the value. Click the amplitude text or press and hold the amplitude
value, and the pop-up box "Input AMP" will pop up, and input the
corresponding value. As shown in Figure 3-9-14 below.
Offset: Click the offset value to make the cursor select the digit. You can press
the left and right direction keys to change the digit and adjust the value with the
knob. Click the offset text or press and hold the offset value, the "Input Offset"
pop-up box will pop up, input the corresponding value. As shown in Figure
3-9-15 below.
Duty cycle: Click on the value of the duty cycle to make the cursor select the
digit. You can press the left and right direction keys to change the digit and use
the knob to adjust the value. Click the duty text or press and hold the duty
cycle value, and the “Input Duty” pop-up box will pop up, input the
corresponding value. As shown in Figure 3-9-16 below.
Phase: Click the phase value to make the cursor select the digit, you can press
the left and right direction keys to change the digit and use the knob to adjust
the value. Click the phase text or press and hold the phase value, the "Input
Phase" pop-up box will pop up, input the corresponding value. As shown in
Figure 3-9-16 below. The phase of the CH1 channel refers to the phase
difference between the CH1 signal and the external signal, and the phase of
the CH2 channel refers to the phase difference between the CH1 signal and
the CH2 signal.
Channel output switch: Click the CH1 channel switch to control the CH1
channel signal output ; Click the CH2 channel switch to control the CH2
channel signal output . When the channel output is on, it displays “ON”, and
when the channel output is off, it displays “OFF”, as shown in Figures 3-9-17
and 3-9-18 below.
To Next Page
Loading...