eNet radio hand-held transmitter 1-gang
The status LED lights up for approx. 5 seconds, and the hand-held transmitter is connec-
ted to the actuator. The hand-held transmitter and actuator exit the programming mode
automatically.
If the status LED of the radio transmitter flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. The actuator is outside
radio range, not in programming mode or there are radio faults.
If the status LED of the actuator flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. All the memory locations
in the actuator or radio transmitter are occupied.
Press the
Prog
button once again for longer than 4 seconds to terminate the programming
mode earlier.
Disconnecting connection to an actuator
￭ Carry out the same steps as when connecting (see the chapter Connecting to radio actu-
ator).
The status LED of the actuator flashes quickly for 5 seconds. The actuator is disconnec-
ted from the radio transmitter. The actuator and radio transmitter exit the programming
mode automatically.
Reset button
All connections of the button (2) to the actuators are disconnected and parameters are reset to
default setting.
The connections in the actuators are preserved and must be deleted separately.
￭ Press the
Prog
button for longer than 20 seconds.
The status LED (1) flashes red after 4 seconds. The status LED flashes faster after
20 seconds.
￭ Release the
Prog
button and press the button (2) briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The button (2) is reset. The setting as channel button or scene button is retained.
Resetting the hand-held transmitter to the default setting
All connections to actuators are disconnected and parameters are reset to default setting.
The connections in the actuators are preserved and must be deleted separately.
￭ Press the
Prog
button for longer than 20 seconds.
The status LED (1) flashes red after 4 seconds. The status LED flashes faster after
20 seconds.
￭ Release the
Prog
button and press the
Prog
button briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The hand-held transmitter is reset to default setting. Button (2) is set as channel button.
7 Disposal of batteries
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
8 Technical data
Rated voltage DC 3 V
Battery type 1×Lithium CR 2450N
Ambient temperature -5 ... +45 °C
4 / 6
82582533 20.12.2019
J0082582533
To Next Page
Loading...
Need help?
General