Jung FMHS1T - Parameter List; 10 Troubleshooting

eNet radio hand-held transmitter 1-gang
Degree of protection IP20
Dimensions L×W×H 55×40.5×15 mm
Radio frequency 868.0 ... 868.6 MHz
Transmission capacity max. 20 mW
Transmitting range in free field typ. 100 m
Receiver category 2
9 Parameter list
The device parameters can be changed with the eNet server:
Device configuration
Parameter name Setting options, Basic setting Explanations
Function Button, Other modes, Unused
Basic setting: Button
Button
The channel works as a chan-
nel button.
Other modes
The channel works as a scene
button.
Unused
The channel is not displayed
in the
eNet SMART HOME
app
and is disabled for use in
the commissioning interface.
Operating mode App use, lock-out protection,
forced operation, wind alarm,
sun protection, twilight
Basic setting: App use
Setting the type of scene used
for a scene button.
Advanced device settings
Parameter name Setting options, Basic setting Explanations
Manual commissioning On, Off
Basic setting: On
Disables manual commission-
ing for all device channels.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Extended channel settings
Parameter name Setting options, Basic setting Explanations
Manual commissioning On, Off
Basic setting: On
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Local Operation On, Off
Basic setting: On
Blocks the device channel for
local operation.
10 Troubleshooting
After a button has been pressed, the status LED flashes red slowly for 3 seconds.
Cause: Battery in the hand-held transmitter is almost empty.
5 / 6
82582533 20.12.2019
J0082582533