eNet radio hand-held transmitter 1-gang
Changing the battery (see chapter Commissioning – Inserting the battery).
Receiver does not react, status LED displays a transmission error. Status LED flashes red
quickly for 3 seconds.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Using a radio repeater.
Cause 2: Actuator is not ready for operation.
Check the actuator and mains voltage.
Cause 3: There are radio faults, e.g. through outside radio.
Eliminate radio interference.
The actuator causing the transmission error can be removed from the display of transmis-
sion errors. To do this, briefly press the
Prog
button of the hand-held transmitter during
signalling. The actuator is automatically taken into account again when it transmits a
status message after radio transmission.
After a button has been pressed, the status LED flashes red quickly for 3 seconds.
Cause: Maximum permitted transmission period (statutory Duty Cycle Limit) has almost been
reached. For the function of the transmitter to continue, the polling and display of the sum status
will be switched off. As soon as sufficient transmission time is available again, the sum status
will again be polled on button actuation.
Actuate the transmitter again after a short waiting time, normally a few seconds.
Reduce the number of actuations.
Reduce the number of actuators connected to the transmitter.
11 Conformity
Albrecht Jung GmbH & Co. KG hereby declares that the radio system type art. no. FMHS1T
meets the directive 2014/53/EU. You can find the full article number on the device. The com-
plete text of the EU Declaration of Conformity is available under the Internet address:
www.jung.de/ce
12 Warranty
The warranty is provided in accordance with statutory requirements via the specialist trade.
ALBRECHT JUNG GMBH & CO. KG
Volmestraße 1
58579 Schalksmühle
GERMANY
Telefon: +49 2355 806-0
Telefax: +49 2355 806-204
kundencenter@jung.de
www.jung.de
6 / 6
82582533 20.12.2019
J0082582533
To Previous Page
Loading...
Need help?
General